Pay attention to these steps before laying the floor.

When we are decorating the house, laying the floor is a very important part. In order to ensure that the tiled or wooden floor can be more beautiful, we need to deal with the ground. Then how to deal with the ground before laying the floor, the following article will introduce to you Steps to clean up the floor before laying down the floor.

1: Clean up the construction site

1. Remove putty and latex paint falling on the ground

Many people will always have a lot of putty and latex paint on the ground when decorating their houses. It is recommended that you buy some colored strips and spread them on the ground during the decoration, so that you won’t get rid of the putty and latex paint. So troublesome.

2. Remove the putty residue at the intersection of the ground and the wall, and the loose part of the edge of the putty

Usually when we scrape putty, workers will only scrape it to about the height of the skirting line from the ground. Therefore, those walls that are blocked by the skirting line usually do not scratch the putty. It is recommended that you require it when performing wall treatment The construction crew scraped putty to the bottom of the wall.

3. Clean up the dust on the ground

If there is some small dust on the ground that is difficult to remove, you can first use a latex paint brush to brush all the walls, you can brush out the tiny dust on the wall, and then clean it up.

4. Clean the ground with a mop

Use a mop to clean the ground so that there is no dust on the ground.

5. Floor cleaning

If the floor cleaning work is not done well, it will easily lead to unevenness when laying wooden floors or tiles, and arching and other phenomena. When we install the floor, we need to wait until the floor is dry before laying it.

6. Close the construction site before entering the wooden floor to prevent dust pollution

Then we need to seal the floor and wait for the floor to be laid. If the floor has not been laid for a long time, we need to remove the surface dust before laying the floor.

Two: How to deal with different materials before laying

1. Parquet

When laying the solid wood composite floor, the cement floor should be leveled, and the materials used should be calculated, and a certain expansion joint should be reserved.

2. Tile floor

Whether we are laying tiles dry or wet, we need to consider the ratio of cement and sand. When laying tiles with a large area, we need to leave a certain expansion gap. The gate stones need to be customized and installed in advance.

3. Solid wood flooring

 When laying solid wood floors, in addition to the cement floor leveling, dragon skeletons are also needed, and then the insecticides are pre-buried, and then the materials used are calculated, and one is reserved.